- #GETTING JBIDWATCHER TO LOAD WHEN COMPUTER TURNS ON DRIVERS#
- #GETTING JBIDWATCHER TO LOAD WHEN COMPUTER TURNS ON CODE#
- #GETTING JBIDWATCHER TO LOAD WHEN COMPUTER TURNS ON PC#
Giving a new battery a go is a fine test because it is a cheap test, but I would recommend starting to plan for a new device or power supply like the other contributor did. I still don't know (for sure) what the cause was.
#GETTING JBIDWATCHER TO LOAD WHEN COMPUTER TURNS ON CODE#
If the computer beeps or a light blinks, you can use that error code to attempt to resolve the issue.
#GETTING JBIDWATCHER TO LOAD WHEN COMPUTER TURNS ON DRIVERS#
I was happy it turned on, but afraid to turn it off. Products Software and Drivers Diagnostics Contact Us Business Support My HP Account HP Desktop PCs - Computer beeps or a light blinks during startup If your computer finds a hardware error when you turn it on, it might not start. I was never able to replace the power supply as a test.įurthermore, I think because it was a high quality power supply it didn't die and kept struggling, even though it was providing a suboptimal experience. I kept replacing the battery every few months but ultimately there was something else going on.
#GETTING JBIDWATCHER TO LOAD WHEN COMPUTER TURNS ON PC#
The PC turned on immediately after I pressed the power button and I have not experienced any delays after this. Then I turned it on again and everything worked fine. After I restored and saved the settings I turned off the PC. My motherboard even suggested (via a message on screen) that this was the first time I turned it on. Turn on Main Power, turn on PC, go into BIOS and restore your previous settings.Replace the CMOS battery located on the Motherboard.Jippie! - I saved my config which was custom made by my vendor. I could save about 10 different profiles. I entered BIOS first and tried to find some sort of save function (or I would simply have taken pictures if the BIOS did not support this). Because the batteries at IKEA were very cheap I thought: let's give it a go. I had already contacted my vendor for advice, but over the weekend I visited IKEA and I stumbled upon those CR 2032 Lithium round flat batteries which IKEA calls "PLATTBOJ".īeforehand, while troubleshooting I did find some references to the CMOS battery, but most of the suggestions where leaning towards buying another power supply. The question is: why is my system showing this behaviour and how can I fix it? Do I really need to get another power supply? This hack was starting to get annoying and did not always work. If it did not turn on at all, sometimes I switched off the power supply's main switch and waited 20 seconds then I switched it back and because I have a BIOS setting "turn on after power loss", most of the times the system turned on and booted normally. It did not happen every time I turned on the pc. So the problem seemed to exist in the turning on phase. (If I have diverged from existing terminology, please let me know.) the system booting up: this is just after the system turning on, the bios doing its thing (whatever that all is) and finding the boot device.the system turning on: just after the bower button, you hear the fans start spinning, if you listen closely you can hear the drives start etc.So to be very specific, let's differentiate between: I have read many messages about BIOS POST etc and power supply issues. The system turns on after several seconds of delay (3 to 20 seconds) and boots up.The system turns on normally and boots up.The problem: The computer sometimes only turns on after a delay.Īfter I press the PC's power button three scenarios can happen:
It took me a while to find my solution, so I thought I would post my problem and solution here.
0 kommentar(er)
